Shape Canon C100 C300 C500 paparazzi handle - PAC300

Shape Canon C100 C300 C500 paparazzi handle - PAC300

Canon C100 C300 C500 15 mm base (B15C300)

The SHAPE C300 Baseplate is made specifically for the Canon EOS C100 C300 C500 cameras. This camera accessory provides a small, light setup solution expandable to a more elaborate setup. It features a pair of 15 mm rods that are 12" long through the length of the baseplate. The baseplate attaches underneath the camera with 4 x M4 screws or with 3/8”-16 and 1/4”-20 screws that are included. The baseplate maintains the proper lens center to the rod height for use with available rod mounted accessories. This allows you to use available standard follow focus units, zoom motors, and matte boxes with your camera while using the baseplate.



Paparazzi with Bloc (PA001BLOC)




The SHAPE Paparazzi with Bloc is an ergonomic-designed Paparazzi Handle screwed tight to a Rod Bloc by two 1/4" screws. The Handle features a total of 20 screw-holes for attaching accessories, and the Bloc mounts 15mm rods and keeps the Handle parallel with a camera. You can slide the Bloc up and down the rods and tighten it into position by a red lever on the side. Both the Handle and Bloc are totally solid -- not at all hollow -- and are both water cut / laser cut, as opposed to being molded. The 20 screw-holes are a mix of 1/4", 3/8" and 1/2" sizes and all run completely through from end to end. They are positioned vertically or horizontally along the Handle. The 1/4" and 3/8" holes can take on most any 1/4" and 3/8" accessories like lights, monitors, mics, grips, remote controls, recorders, articulating arms, wireless audio receivers, camera plates, and more. And into the 1/2" holes you can screw in male-threaded SHAPE rods (2ROD15MF4, 2ROD15MF6) . The diverse set of screw-holes lets you get very creative in dressing up your rig. And the ability to screw in rods lets you just as creatively extend your rig.




15 mm 12" rods (15TUBE12)

This pair of SHAPE 15 mm Aluminum Rods (12") connect into your camera rig, extend it, and let you add various SHAPE and third-party accessories compatible with 15 mm rods. With these two rods and with a few fundamental accessories, you can most certainly even begin building your own rig from scratch.
The rods are each 15 mm in diameter, 12 inches long, hollow, non-threaded, and made of reliable aluminum coated with a clear finish.

Features

• Specifically, for Canon C100/C300/C500
  
• Baseplate mounts 15 mm rods
  
• Ergonomic Handle parallel with the camera
  
• Baseplate designed with spring-Loaded Locking Levers
  
• Handle features several 1/4"-20 & 3/8"-16 threaded Holes
  
• The 1/2" holes let you screw in male-threaded rods
  
• Takes on lights, monitors, mics, grips, remote, recorders, arms, receivers, rods
  
• Fully solid and water / laser cut
  
• Holes run completely through from end to end

What's in the Box:

• (1) PAPARAZZI I HANDLE WITH 15MM ROD BLOC SYSTEM
• (1) BASEPLATE WITH ADJUSTABLE ROD BLOC SYSTEM
• (2) 15 MM RODS 12 INCHES