Shape SHAPE kit focus single rod follow focus 15 mm LWs - FA123

Shape SHAPE kit focus single rod follow focus 15 mm LWs - FA123

Use the compact SHAPE Follow Focus Kit with Single 15 mm Rod Clamp with your camera setup to make focus pulling easy. The modular design allows you to add and remove any of the components without screws or tools, and its small profile allows the addition of a matte box or accessories around your lens.  At the core of the kit is a rubber, anti-slip follow focus wheels attached to a single aluminum 15 mm rod clamp. The clamp rotates to adjust to most lens sizes, and it's tightened by a locking lever. The clamp's rotation also allows the focus wheel to easily swing out of the way when changing lenses. Five drive gears are included to fit a variety of lens sizes: 0.5 MOD/78T, 0.6 MOD/64T, 0.8 MOD/38T, 0.8 MOD/43T, and 0.8 MOD/78T. The gears can be flipped from front to back to facilitate different lens configurations. A 49 mm rubber friction wheel is also included for the 0.5 MOD/78T gear which is most commonly used with DSLR lenses. For alternate fine-focus configurations, use the included speed crank or 11" whip, both of which attach to the center point of the knob. Four magnetic marking disks are included to attach to the focus wheel.



At the center of the knob, an ARRI-standard accessory port for attaching separately available accessories such as a whip or a speed crank;

All gears can be flipped to the front or back position which is helpful for compact lens configurations;

Two rotation points (one on the rod and one on the body) allowing you to get the follow focus perfectly aligned vertically on the side of the camera body;

Swing Arm Design allows you to simply pull the follow focus away from the lens for a quick lens change then you can push it back into place when you're ready;

A compact design takes little space, so you can still attach a matte box to the front;

Use the swing arm to properly align the follow focus and then you can tighten the thumbscrew on the bottom to keep it in place.

Features

• Designed for Compact Cameras
  
• Allows addition and removal of components without tools or screws
  
• Follow Focus Wheel with Crank and Whip
  
• Single 15 mm Rod Clamp, Swing Arm Design
  
• 5 x Drive Gears Included, 1:1 Gear Ratio
  
• 4 x Magnetic Marking Disks
  
• Anti-Slip Rubber Focus Knob
  
• Compatible with Most Lenses
  
• Aluminum Construction

What's in the Box:

• (1) FOLLOW FOCUS
• (5) GEAR WHEEL (M 0.5/78T; M 0.6/64T; M 0.8/38T; M 0.8/43T; M 0.8/78T)
• (1) SPEED CRANK
• (1) 11 INCHES WHIP
• (4) MARKING DISK WITH MAGNET
• (1) FRICTION RUBBER WHEEL 49MM