KDS-8F is a high-performance, zero latency, 4K@60Hz (4:4:4) video streaming transceiver for streaming via Ethernet over single-mode and multi-mode optical fiber. KDS-8F can be set as either an encoder or decoder. As an encoder, it encodes and streams the HDMI or DisplayPort input along with IR, RS-232, analog audio and USB, over an IP network.
Kramer Electronics KDS-8F Zero Latency 4K HDR SDVoE Video Streaming Transceiver over Fiber Optic
KDS-8F is a high-performance, zero latency, 4K@60Hz (4:4:4) video streaming transceiver for streaming via Ethernet over single-mode and multi-mode optical fiber. KDS-8F can be set as either an encoder or decoder. As an encoder, it encodes and streams the HDMI or DisplayPort input along with IR, RS-232, analog audio and USB, over an IP network. As a decoder, it receives the encoded signal and decodes it for output.
High-Performance Video Streaming Transceiver Streams up to 4K@60Hz (4:4:4) resolution signals over a 10G network interface, providing lossless compression.
Maximum Compatibility Fully standard and compliant SDVoE codec, enables compatibility with other software and hardware streaming platforms.
HDCP 2.2 Compliant, HDR Support, Genlock and Fastswitch Modes Support.
High-Speed 10G Network Switch Managed switch provides multicast, jumbo frames, IGMP snooping and fast leave.
Analog Audio Embedding Provides an unbalanced analog audio port for embedding audio into the streaming signal.
Bi-directional USB over IP.
Bidirectional IR and RS232 over IP Control an IR or serial device located on the decoder side from the encoder and vice versa.
Video Wall Support.
Multiview Support.
Easy, CostEffective Maintenance LED indicators for main power, Tx/Rx mode setting, HDMI/ DisplayPort video source detection, USB connection and Tx and Rx transmission enable easy local maintenance and troubleshooting.
Simple System Management Remote system management support to enable quick and efficient remote system and device life-cycle management.
Specifications:
High-Performance Video Streaming Transceiver Streams up to 4K@60Hz (4:4:4) resolution signals over a 10G network interface, providing lossless compression.
Maximum Compatibility Fully standard and compliant SDVoE codec, enables compatibility with other software and hardware streaming platforms.
HDCP 2.2 Compliant, HDR Support, Genlock and Fastswitch Modes Support.
Analog Audio Embedding Provides an unbalanced analog audio port for embedding audio into the streaming signal.
Bidirectional IR and RS232 over IP Control an IR or serial device located on the decoder side from the encoder and vice versa.
Video Wall Support.
Multiview Support.
Easy, CostEffective Maintenance LED indicators for main power, Tx/Rx mode setting, HDMI/ DisplayPort video source detection, USB connection and Tx and Rx transmission enable easy local maintenance and troubleshooting.
Simple System Management Remote system management support to enable quick and efficient remote system and device life-cycle management.
High-Speed 10G Network Switch Managed switch provides multicast, jumbo frames, IGMP snooping and fast leave.
1 HDMI: On a female HDMI connector
1 DisplayPort: On a female DisplayPort connector
1 IR: On a 3.5mm mini jack
1 HDMI: On a female HDMI connector
1 IR: On a 3.5mm mini jack
1 SFP+ Fiber On LC connector(s) for 10GbE Ethernet (MM SFP+ transceiver module included)
1 Unbalanced Stereo Audio: On a 3.5mm mini jack
1 1GbE Ethernet: On an RJ45 connector
1 RS-232: On a 3pin terminal block connector
3 USB: On female USB type-A connectors
1 USB: On a USB mini connector
Standards Compliance: 10/12bit HDR (PointtoPoint and Genlock mode only), HDCP 2.2 &1.4, DVI 1.0,
Signal Compression: Ultralight compression, lossless for most content
Maximum Range in PointToPoint Mode Using OM3 multi-mode fiber - 300m (980ft) / Using OM4 multi-mode fiber 550m (1800ft) / Using single-mode fiber 30km (18.6 miles).
Standards Compliance: Supports passthrough of audio formats including LPCM 2.0/5.1/7.1, Bitstream and HD Bitstream from HDMI sources
Source: 12V DC
Consumption: 1A
Operating Temperature: 0 to + 45C (32 to + 113 F), 10% to 90%, noncondensing
Storage Temperature: 20 to +70C (4 to + 158 F), 10% to 90%, noncondensing
Humidity: 10% to 90%, noncondensing
Bi-directional USB over IP.
Included Power adapter, multimode SFP+ transceiver module, rubber feet
Optional Single-mode SFP+ transceiver module
Product Dimensions: 20.00cm x 23.10cm x 2.50cm (7.87" x 9.09" x 0.98" ) W, D, H
Shiping Dimensions: 38.20cm x 20.00cm x 7.00cm (15.04" x 7.87" x 2.76" ) W, D, H