KDS-8 is a high-performance, zero latency, 4K@60Hz (4:4:4) video streaming transceiver for streaming via Ethernet over copper cable. KDS-8 can be set as either an encoder or decoder. As an encoder, it encodes and streams the HDMI input along with IR, RS-232, and analog audio, over an IP network.
Kramer Electronics KDS-8 Zero Latency 4K HDR SDVoE Video Streaming Transceiver over Copper
KDS-8 is a high-performance, zero latency, 4K@60Hz (4:4:4) video streaming transceiver for streaming via Ethernet over copper cable. KDS-8 can be set as either an encoder or decoder. As an encoder, it encodes and streams the HDMI input along with IR, RS-232, and analog audio, over an IP network. As a decoder, it receives the encoded signal and decodes it for output.
HighPerformance Video Streaming Transceiver Streams up to 4K@60Hz (4:4:4) resolution signals over a 10G network interface, providing lossless compression.
Maximum Compatibility Fully standard and compliant SDVoE codec, enables compatibility with other software and hardware streaming platforms.
HDCP 2.2 Compliant, HDR Support, Genlock and Fastswitch Modes Support
HighSpeed 10G Network Switch Managed switch provides: multicast, jumbo frames, IGMP snooping and fast leave.
Analog Audio Embedding Provides an unbalanced analog audio port for embedding audio into the streaming signal.
Bidirectional IR over IP Control an IR device located on the decoder side from the encoder and vice versa.
Bidirectional RS232 over IP Control a serial device located on the decoder side from the encoder and vice versa.
Video Wall Support.
Multiview Support
Easy, CostEffective Maintenance LED indicators for main power, Tx/Rx mode setting, HDMI video source detection, and Tx and Rx transmission enable easy local maintenance and troubleshooting.
Simple System Management Remote system management support to enable quick and efficient remote system and device life-cycle management.
Specifications:
1 HDMI: On a female HDMI connector
1 IR: On a 3.5mm mini jack
1 HDMI: On a female HDMI connector
1 IR: On a 3.5mm mini jack
1 10GbE Ethernet: On an RJ45 connector
1 Unbalanced Stereo Audio: On a 3.5mm mini jack
1 1GbE Ethernet: On an RJ45 connector
1 RS-232: On a 3pin terminal block connector
Standards Compliance: 10/12-bit HDR (Point-to-Point and Genlock mode only), HDCP 2.2 &1.4, DVI 1.0,
Signal Compression: Ultra-light compression, lossless for most content
Range: Up to 100m in point-to-point mode
Standards Compliance: Supports pass-through of audio formats including LPCM 2.0/5.1/7.1, Bitstream and HD Bitstream from HDMI sources
POWER:
Source: 12V DC
Consumption: 3A
Operating Temperature: 0 to + 45C (32 to + 113 F), 10% to 90%, noncondensing
Storage Temperature: 20 to +70C (4 to + 158 F), 10% to 90%, noncondensing
Humidity: 10% to 90%, noncondensing
HighPerformance Video Streaming Transceiver Streams up to 4K@60Hz (4:4:4) resolution signals over a 10G network interface, providing lossless compression.
Maximum Compatibility Fully standard and compliant SDVoE codec, enables compatibility with other software and hardware streaming platforms.
HighSpeed 10G Network Switch Managed switch provides: multicast, jumbo frames, IGMP snooping and fast leave.
Analog Audio Embedding Provides an unbalanced analog audio port for embedding audio into the streaming signal.
Bidirectional IR over IP Control an IR device located on the decoder side from the encoder and vice versa.
Bidirectional RS232 over IP Control a serial device located on the decoder side from the encoder and vice versa.
Video Wall Support.
Easy, CostEffective Maintenance LED indicators for main power, Tx/Rx mode setting, HDMI video source detection, and Tx and Rx transmission enable easy local maintenance and troubleshooting.
Simple System Management Remote system management support to enable quick and efficient remote system and device life-cycle management.
HDCP 2.2 Compliant, HDR Support, Genlock and Fastswitch Modes Support